P0E5B
DC/DC Converter Temperature Sensor C Circuit High
P0E5B is stored when the signal of DC/DC converter temperature sensor C rises above its valid window. On an NTC circuit with pull-up resistor, that is the typical picture of an unplugged connector, a broken wire or a short to a supply voltage, and it reads as a converter far colder than possible. No manufacturer documents P0E5B publicly. Ford's limit for its sensor C, the boost converter inductor sensor, lies at 4.86 V; above that a fault is logged, yet Ford reports it as P0E59. Range checks of this kind are mandatory under CARB for hybrid inputs. Since a cold reading would hide real overheating, the controller treats the converter temperature as unknown and usually limits power. A connector check is the obvious first step. P0E5A is the low-signal counterpart.
Possible causes
- Connector unplugged or sensor wire broken high
- Signal shorted to a supply voltage medium
- Thermistor open internally medium
Symptoms
- Hybrid system warning
- Power limited as a precaution
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E5B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.