P0E5A
DC/DC Converter Temperature Sensor C Circuit Low
P0E5A means the voltage from DC/DC converter temperature sensor C has fallen below its valid window. With the NTC thermistors common in power electronics, a low voltage translates into an implausibly hot reading, so a grounded signal wire or a failed sensor is far more likely than genuine overheating. No manufacturer documents P0E5A publicly. Ford gives an idea of the window for its sensor C, the inductor sensor of the boost converter: anything under 0.067 V counts as a fault, but Ford stores it as P0E59, not as P0E5A. CARB requires out-of-range monitoring of hybrid input components. Because the controller must assume overtemperature, it usually derates the converter at once, which can reduce electric power. The high-signal counterpart is P0E5B.
Possible causes
- Sensor signal shorted to ground high
- Thermistor internally shorted medium
- Evaluation circuit in the converter faulty low
Symptoms
- Hybrid system warning
- Converter derated, reduced electric power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E5A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.