OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E54

DC/DC Converter Current Sensor A Circuit High

P0E54 reports a current sensor A signal above the range the DC/DC converter accepts. Mercedes-Benz uses it explicitly: its bulletin LI54.10-P-079533, covering the EQB (series 243) and the G-Class including the electric G 580 (series 465), defines P0E5400 as a short to positive of the converter's current sensor A. It is one of up to four converter codes, with P0C3B00, P0E9700 and P0C4000, that appear after the converter wakes up incorrectly; drivers see a red 12 V battery message and HV warnings. Mercedes treats it as a state error rather than a broken part: the technician runs the buck mode in XENTRY for about 30 s, checks that output current settles from a high initial value, then clears the memory or resets the converter. The low-signal sibling is P0E53.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 54

Possible causes

  • Converter stuck in a fault state after incorrect wake-up (Mercedes 243/465) high
  • Signal line shorted to a supply voltage medium
  • Current sensor or converter electronics defective low

Symptoms

  • Red 12 V battery message
  • White or yellow high-voltage system warnings
  • Reduced drive power

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E54

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication