P0E52
DC/DC Converter Current Sensor A Circuit Range/Performance
P0E52 is the plausibility test of current sensor A: the signal is electrically valid, yet the measured current does not fit what the converter is doing. Two makers name it. FCA lists it for the 2021 Ram 1500 with the 3.6 litre eTorque mild hybrid; bulletin 08-037-21 brings new HCP software and turns P0E52 from a two-trip into a one-trip code, so the MIL may light after a single faulty drive. Ford reports it from the inverter system controller of the 2024–2026 Lincoln Nautilus and the 2025–2026 Maverick hybrid, together with several motor and inverter codes; the car loses power and shows Stop Safely Now or Service Vehicle Soon, and the special service message tells dealers to replace that controller. Pure circuit faults are P0E51, P0E53 and P0E54.
Possible causes
- Control software with unsuitable limits (FCA eTorque HCP update) high
- Internal fault of the inverter system controller (Ford hybrid) medium
- Current sensor drifting or offset out of tolerance medium
- High resistance at sensor connector or ground low
Symptoms
- MIL on, often after only one drive
- Limited power with Stop Safely Now or Service Vehicle Soon message
- Reduced eTorque assist or start/stop function
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E52
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.