OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E4F

Motor Electronics Coolant Pump A Control Circuit Intermittent/Erratic

P0E4F covers coolant pump A of the motor electronics loop, which cools the inverter and drive motor, and sets when the signal exchanged with the pump becomes unstable rather than permanently open or shorted. Ford uses exactly this code in the OBD summaries for its hybrid and plug-in hybrid models of 2015 to 2019: the pump reports back to the module, and P0E4F is stored when that feedback is outside the expected frequency or duty cycle for more than 1 s. The check runs continuously from 500 ms after power-up with 6 to 19 V on the 12 V network, next to P0A05 (no response for over 9.25 s), P0A06 and P0A07 (driver faults) and P0C73 (pump reports an internal fault). Loose pins or moisture in the pump connector are typical; overheat protection may cut power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 4F

Possible causes

  • Loose, corroded or wet pins in the pump A connector high
  • Chafed command or feedback wire that loses contact intermittently medium
  • Failing electronics inside the pump sending an unstable feedback signal medium
  • Unstable 12 V supply or poor ground at the pump low

Symptoms

  • MIL or hybrid system warning
  • Power reduction when inverter or motor temperature rises
  • Fault may clear itself and return later

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0E4F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication