P0E49
Hybrid/EV Battery Pack Voltage Sense F Circuit
Channel F is the sixth and last pack voltage measurement in this series and comes after channel E (P0E44 to P0E48). P0E49 is its general circuit fault: the battery controller cannot use the input, for instance because the sense line is open, the measuring chip reports an internal error or the raw value is missing, while no clear low, high or erratic pattern applies. No manufacturer documents P0E49 publicly. Systems that compare several high-voltage measurements, as GM's 2019 hybrids do between the pack sensor and the inverter and charger bus voltages, depend on every channel being valid. CARB requires all battery voltage sensors of the storage system to be monitored. The vehicle typically limits or refuses high-voltage operation.
Possible causes
- Open sense lead or disconnected connector of channel F high
- Internal fault of the voltage measuring chip or battery controller medium
- Moisture or corrosion in the pack-side connector low
Symptoms
- High-voltage warning and reduced power
- Vehicle may refuse to become ready
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E49
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.