P0E39
DC/DC Converter Voltage Sensor B High
P0E39 reports that sensor B of the DC/DC converter reads far too high, a pattern GM attributes to a short to battery. The 2025 engine tables (25OBDG03A) set the bar at more than 28 V for raw voltage value 2, again needing 320 failing samples within 400 at 12.5 ms and a battery voltage of at least 6.6 V, with Type B confirmation over two trips. If only sensor B shows the excess while sensor A and the ECM's own run/crank reading stay normal, a wiring fault on the B path is far more likely than a converter that really puts out such a voltage. A lost reference ground can also let the signal float upward. Sensor A's high code is P0E34; a low reading on sensor B is P0E38, an implausible but valid one P0E37.
Possible causes
- Sensor B signal shorted to a voltage-carrying wire high
- Open reference ground letting the signal float high medium
- Failed measuring circuit for sensor B low
Symptoms
- MIL on after two trips (GM)
- Start-stop switched off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0E39
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.