P0E36
DC/DC Converter Voltage Sensor B Circuit
P0E36 is the catch-all circuit code for the second voltage measurement of a DC/DC converter, sensor B. Where a converter reads both its input and its output, or monitors one rail twice, the second path gets the letter B; FCA names it voltage sensor 2 on the 2021 Ram 1500 eTorque. No manufacturer documents P0E36 itself in public sources. GM's 2025 engine tables treat sensor B through its sibling codes only: below 1 V is P0E38, above 28 V is P0E39, and a gap of more than 2 V to the ECM run/crank voltage is P0E37. P0E36 is left for electrical faults that fit none of those, such as an open line the controller recognises as such. CARB asks for circuit faults of inputs to be detected separately where feasible. Converter output may be reduced.
Possible causes
- Open sense wire or unplugged connector high
- Second measuring path inside the converter failed medium
- Poor ground of the converter low
Symptoms
- Warning light, possibly 12 V battery warning
- Start-stop disabled or converter output reduced
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0E36
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.