P0E34
DC/DC Converter Voltage Sensor A High
With P0E34 the controller sees a voltage on sensor A of the DC/DC converter that is too high to be real, which points to the signal being shorted to a battery feed or another live wire. In GM's 2025 tables (25OBDG03A) the ECM flags it when raw voltage value 1 exceeds 28 V, far above anything a 12 V converter output should reach. Sampling and confirmation mirror the low case: 320 of 400 readings must fail, battery voltage must be 6.6 V or more, and as a Type B fault it needs two trips before the MIL lights. A real overvoltage of the converter would not normally reach that value, so the wiring and the sensing path come first. Low readings on the same sensor use P0E33; sensor B has P0E39 for the same fault.
Possible causes
- Signal wire shorted to a battery feed or other live circuit high
- Lost reference ground of the measurement, signal floats high medium
- Faulty measuring circuit in the converter low
Symptoms
- MIL on after two trips (GM)
- Engine auto-stop disabled
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0E34
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.