OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E33

DC/DC Converter Voltage Sensor A Low

P0E33 means the controller reads an implausibly low value from voltage sensor A of a DC/DC converter, typically because the signal wire is shorted to ground. GM documents it in its 2025 engine control tables (25OBDG03A) for a converter that keeps the 12 V network stable while the engine restarts automatically: the raw voltage value 1 must drop below 1 V, and 320 failing samples out of 400 taken every 12.5 ms, about four seconds, are needed. The test runs with at least 6.6 V battery voltage in run/crank or accessory mode. GM rates it Type B, so the MIL comes on after two trips. P0E34 is the opposite case on the same sensor, P0E38 the matching fault on sensor B. Start-stop and the 12 V support can be limited.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 33

Possible causes

  • Sensor signal wire chafed through to ground high
  • Voltage measurement inside the converter failed medium
  • Moisture in the converter connector bridging to ground low

Symptoms

  • MIL on after two trips (GM)
  • Auto stop/start no longer available
  • Possible 12 V voltage dips during engine restarts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0E33

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication