OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E2A

Drive Motor Inverter Temperature Sensor H Circuit Low

P0E2A reports that inverter temperature sensor H delivers a voltage below its lower limit. Mitsubishi's 2023 Outlander PHEV assigns the code to IGBT sensor 8 (V-phase H2) of the front motor control unit, triggered by a voltage at or under 1.25 V lasting 0.08 s while the supply is 8 V or higher; the MIL comes on. Sensor 8 is the last one with a generic code there: for sensors 9 to 12 Mitsubishi falls back on its own P301x codes, since the generic list stops at H. If the circuit is an NTC divider of the type GM documents, low voltage reads as excessive heat, so a ground short makes the inverter look overheated and power is cut back. Genuine phase overheating is a separate code; the high-side fault is P0E2B.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 2A

Possible causes

  • Signal of sensor H shorted to ground high
  • Shorted thermistor element medium
  • Moisture or coolant damage on the sensing board low

Symptoms

  • MIL and hybrid warning light on
  • Power reduction similar to an overheating inverter

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E2A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication