OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E25

Drive Motor Inverter Temperature Sensor G Circuit Low

P0E25 means the voltage of inverter temperature sensor G has fallen below its valid window. In the 2023 Outlander PHEV, Mitsubishi assigns it to the U-phase H2 sensor of the front motor control unit and sets P0E25-00 once that signal does not rise above 1.25 V during 0.08 s with a unit supply of 8 V upward; the MIL is switched on together with the hybrid warning lamp. Mitsubishi states only the voltage. For an NTC element fed through a pull-up resistor, as GM describes for its inverter sensors, a low voltage equals a very hot sensor, so a ground short or a damaged sensing line looks like an overheated switch. Real overheating is reported by separate temperature codes. The opposite limit is P0E26; the sensor is not sold separately.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 25

Possible causes

  • Sensor signal shorted to ground inside the inverter high
  • Thermistor internally shorted medium
  • Damaged sensing board, e.g. after coolant ingress low

Symptoms

  • MIL and hybrid warning light on
  • Motor power limited as if the inverter were overheating

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E25

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication