OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E24

Drive Motor Inverter Temperature Sensor G Circuit Range/Performance

P0E24 is the plausibility test of inverter temperature sensor G: the signal is electrically fine, but the temperature it reports does not fit. Mitsubishi uses the code on the 2023 Outlander PHEV for IGBT sensor number 7 in the front motor control unit, labelled U-phase H2. The check runs only after a soak of at least 600 s, with the IGBTs shut down and the unit fed with 8 V or more, within 1.5 s of these conditions being met. Should it then deviate from either of two other IGBT temperatures by more than 47 °C for 0.1 s, P0E24-00 is logged; MIL and plug-in hybrid warning light both light up. After a long stand all switches should be equally warm, so the code points to a drifting sensor. Mitsubishi's flow ends with a new power drive unit.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 24

Possible causes

  • Sensor G reads offset against the other IGBT sensors high
  • Fault on the sensing circuit of the power drive unit medium
  • Uneven inverter cooling, e.g. air in the coolant circuit low

Symptoms

  • MIL and plug-in hybrid warning light on
  • Often no noticeable change in driving

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E24

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication