P0E23
Drive Motor Inverter Temperature Sensor G Circuit
P0E23 is the catch-all circuit code of drive motor inverter temperature sensor G, a thermistor that watches the power switches of the motor inverter. It stands for an electrical fault the controller cannot pin down as low, high or erratic. No manufacturer documents P0E23 publicly. The only published user of the G series is Mitsubishi: in the 2023 Outlander PHEV the seventh IGBT sensor of the front motor unit (U-phase H2) reports its faults as P0E24, P0E25 and P0E26, but not as P0E23. CARB requires hybrid input components to be tested for open circuits and out-of-range signals. Without a valid temperature the inverter is usually run with reduced torque; the sensor sits inside the inverter, so repair often means that assembly.
Possible causes
- Temperature sensor or sensing board inside the inverter failed high
- Poor contact at an internal or external inverter connector medium
- Faulty evaluation input in the motor control unit low
Symptoms
- Hybrid system warning light and MIL on
- Reduced electric drive power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E23
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.