OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E20

Hybrid/EV Battery Pack Coolant Control Valve A Control Circuit Driver Current/Temperature Too High

P0E20 points at the driver that powers coolant control valve A: its output has exceeded a current limit or run too hot and switched itself off. No manufacturer documents P0E20 publicly. Valve A is often a small motor actuator; on the 2011 Chevrolet Volt it is driven in both directions through two drive lines, each with its own ground and voltage short checks (90 failures in 100 samples at 6.25 ms, Type B). Driving a motor into a jammed end stop is exactly what heats such a stage, so a sticking valve is a prime suspect. Mercedes reports the electrical fault of its battery shutoff valve as P0CDF00 instead. TI's automotive smart switches illustrate the protection itself: shut-off at the current limit or near 150 °C, with a fault flag. P0E21 and P0E22 cover valves B and C.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 20

Possible causes

  • Valve A sticking or jammed so the actuator stalls high
  • Partial short in the valve actuator motor or its wiring medium
  • Degraded valve driver in the control module low

Symptoms

  • Check engine light on
  • Valve A stays in its last position
  • Battery runs too warm or too cold, power or charging limited

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0E20

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication