OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E1F

Hybrid/EV Battery Pack Coolant Pump A Control Circuit Driver Current/Temperature Too High

P0E1F reports that the output stage switching battery coolant pump A has hit its current or temperature limit. Ford uses the code on its 2020 hybrids. On the Escape HEV built up to 10 June 2020, bulletin 20-2221 lists P0E1F in the battery energy control module beside pump and battery codes and blames strategies in the BECM software, fixed by reprogramming PCM and BECM. Bulletins 20-2293 and 20-2345 name it for the Explorer, Police Interceptor Utility and Aviator hybrids, with the MIL on and a BECM update as the cure. If software is ruled out, the hardware logic applies: smart switches such as TI's automotive high-side parts shut off at their current limit or around 150 °C and report the event. A stiff pump, a short in the motor or a heat-soaked module remain. Pump B has the same code as P0E1E.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 1F

Possible causes

  • Battery energy control module software (Ford 2020 hybrids) high
  • Pump A binding or seized and drawing excess current medium
  • Partial short in the pump motor or harness medium
  • Output driver overheating in the module low

Symptoms

  • Check engine light on
  • Battery coolant pump stops intermittently
  • Hybrid power limited when the battery gets warm

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0E1F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication