OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E1E

Hybrid/EV Battery Pack Coolant Pump B Control Circuit Driver Current/Temperature Too High

P0E1E does not describe the wire or the pump directly but the switching stage that drives pump B: that driver has reported excess current or overheating and has protected itself. Such smart switches measure their own state; a TI automotive high-side switch, for example, turns off at about 150 °C junction temperature or on reaching its current limit and signals the fault on a diagnostic pin. No manufacturer documents P0E1E publicly. GM's 2019 tables show a comparable monitor for a different load, the fuel pump driver code P1255: a board temperature of 160 °C or more, 3 failures in 15 samples, Type B. A pump that drags or seizes, a partial short in the motor or a hot mounting spot of the module are typical. Pump A has the same code as P0E1F.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 1E

Possible causes

  • Pump B binding or seized, drawing too much current high
  • Partial short in the pump motor or its wiring medium
  • Driver in the module overheating due to location or poor cooling medium
  • Degraded output driver in the control module low

Symptoms

  • Check engine light on
  • Pump B switches off intermittently
  • Battery or electronics temperature rises, power is limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0E1E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication