OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E1D

Hybrid/EV Battery Pack Coolant Pump B Control Performance

P0E1D says pump B accepts its command electrically but the effect the controller looks for does not appear, such as the expected flow, speed or temperature change in its loop. No manufacturer documents P0E1D publicly. The model is pump A on the 2011 Chevrolet Volt: once the pump has run for over 60 s, the pack inlet coolant temperature must have shifted by at least 5 °C, otherwise a Type B code is set. GM bulletin PI0798A traces that pump A code after a drain and refill to trapped air, cleared with a vacuum purge, which is also the first check for pump B after service work. CARB calls for a functional check of battery cooling where feasible. Worn bearings, a clogged inlet or a sensor reading wrongly are further causes. Pump B speed faults may also show as P2CF6 or P2CF7.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 1D

Possible causes

  • Air trapped in the loop after a coolant service high
  • Worn pump B or debris blocking its impeller or inlet medium
  • Low coolant level or leak in the battery loop medium
  • Coolant temperature sensor giving an implausible value low

Symptoms

  • Check engine light on
  • Battery or electronics temperatures higher than normal
  • Gurgling noise from the coolant loop
  • Power or charging rate limited

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0E1D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication