P0E1C
Hybrid/EV Battery Pack Coolant Pump B Control Circuit High
P0E1C is set when the command signal to battery coolant pump B stays above what the controller allows, for instance because the line is shorted to battery voltage or, on a pulled-up PWM input, interrupted. No manufacturer documents P0E1C publicly. Its pump A counterpart P0C49 appears in Ford bulletin 20-2293 for the 2020 Lincoln Aviator hybrid among MIL codes for the coolant pumps, with BECM reprogramming as the fix. In contrast to a ground short, a line held high can either keep a simple on/off pump running continuously or, with PWM pumps that read a steady high as an invalid command, make the pump fall back to a default speed or stop. CARB requires circuit monitoring of thermal management outputs. Look for a wire touching a live feed. P0E1B is the low case, P0E1A the open circuit.
Possible causes
- Pump B control wire shorted to battery voltage high
- Interrupted pulled-up PWM input at the pump medium
- Control module software fault, as Ford found for pump A low
Symptoms
- Check engine light on
- Pump B runs constantly or not at all
- Reduced power under heavy load
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0E1C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.