P0E1B
Hybrid/EV Battery Pack Coolant Pump B Control Circuit Low
P0E1B narrows a pump B command fault down to a level below the expected window, normally because the control or PWM wire has a ground fault, or because a driver that cannot raise it. No manufacturer documents P0E1B publicly. The nearest documented relative is P0C48 for pump A, which Ford listed for the 2020 Explorer, Police Interceptor Utility and Lincoln Aviator hybrids and traced to battery energy control module software that is reprogrammed. A software cause of that kind is worth ruling out first before cutting into the harness. Physically, a low reading often comes from insulation rubbed through on a bracket or from coolant wicking into the connector. CARB wants each thermal management output checked for such faults. If pump B stops as a result, the loop it serves loses flow. Open circuit is P0E1A, short to voltage P0E1C.
Possible causes
- Pump B control or PWM wire shorted to ground high
- Coolant or water in the pump connector medium
- Control module software fault, as seen by Ford on the pump A sibling medium
- Internal short at the pump B control input low
Symptoms
- Check engine light on
- Pump B does not run
- Power limited when the components it cools get hot
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0E1B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.