OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E14

Hybrid/EV Battery Pack Coolant Heater A Control Circuit High

P0E14 is logged when heater A's control wire sits too high, typically because it touches a supply voltage or because a pulled-up input has lost its connection. No manufacturer documents P0E14 publicly; GM's 2016 Volt reports open, ground and voltage faults of its heater transistor together as P1EC3 (Type B). The high case deserves care because, depending on the design, a line held at supply voltage can keep the heater energised against the controller's will. Heater makers guard against that: a patent now held by PTI EV Hybrid describes a battery coolant heater with a thermistor in its housing that cuts power when the coolant warms faster than a set rate. CARB requires circuit monitoring of battery heating outputs. P0E13 is the low counterpart, P0E12 the open circuit.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 14

Possible causes

  • Command wire shorted to a supply or neighbouring live wire high
  • Open connection on a pulled-up heater input reading as high medium
  • Output driver in the controller that will not switch off medium

Symptoms

  • Check engine light on
  • Heater shut down by its own overheat protection
  • Battery heating unavailable or erratic in cold weather

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0E14

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication