OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E13

Hybrid/EV Battery Pack Coolant Heater A Control Circuit Low

P0E13 is the low-signal case on the command line of battery coolant heater A: the controller reads the line near ground at a moment when it expects a higher level, which points to a short to ground or a driver that cannot pull the circuit up. No manufacturer documents P0E13 publicly. GM's 2016 Volt folds open circuit, ground short and voltage short of its battery heater transistor into the single code P1EC3, rated Type B. Keep this low-voltage command fault apart from an isolation fault of the high-voltage heater element: GM bulletin PIC5920B lists the battery heater of the 2011–2014 Volt and 2014 ELR as one possible cause of isolation codes. CARB requires circuit checks on battery heating outputs. With the heater stuck off, winter charging slows down. P0E12 is the open circuit, P0E14 the high case.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 13

Possible causes

  • Command wire shorted to ground, e.g. chafed against the body high
  • Moisture or coolant in the heater connector medium
  • Internal short in the heater's control input medium
  • Output driver in the controller stuck low low

Symptoms

  • Check engine light on
  • Battery heater does not work at low temperatures
  • Longer charging times in winter

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0E13

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication