OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E12

Hybrid/EV Battery Pack Coolant Heater A Control Circuit/Open

P0E12 concerns the command circuit of battery coolant heater A, the electric element that warms the coolant sent to the hybrid or EV battery when the pack is too cold for charging or full power. The controller flags it when this circuit is open or otherwise electrically faulty. No manufacturer documents P0E12 publicly. GM's 2016 Volt shows the same check under its own code P1EC3: above 10.2 V system voltage, 20 failed readings within 40 samples taken every 100 ms set a Type B code. CARB requires every electronic output used to heat the energy store to be checked for circuit faults. Typical finds are a cracked conductor, an unseated connector or a dead output stage. In frost the car may then limit charging or rely on the engine. Shorts to ground or voltage are P0E13 and P0E14.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 12

Possible causes

  • Broken or chafed wire in the heater A command circuit high
  • Loose, corroded or unlocked connector at the heater or controller high
  • Open circuit inside the heater A assembly medium
  • Failed output driver in the controlling module low

Symptoms

  • Check engine light on
  • Slow or reduced charging in cold weather
  • Engine runs more often than usual on cold days
  • Reduced electric power until the pack warms up

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0E12

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication