OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E0F

Generator Inverter Power Supply A Circuit/Open

P0E0F is set when the generator inverter loses one of its internal supplies, supply A, or the line to it is interrupted. Which supply carries the letter A is up to the manufacturer; usually it is the low-voltage feed of the gate drivers that switch the power transistors. No manufacturer documents P0E0F publicly. The drive motor counterpart P0C0B shows how such a check works at GM: the IGBT module itself reports a bias fault once its gate drive supply drops below a threshold, which the 2011 Volt treats as Type A after a single 2.08 ms event and a 2019 table after 0.168 s within a 0.2 s window. CARB requires circuit monitoring of hybrid components. Without gate drive supply the generator cannot be controlled at all. Low and high variants: P0E10, P0E11; supply B: P2CC5.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 0F

Possible causes

  • Gate driver supply inside the inverter failed medium
  • 12 V feed, fuse or connector of the inverter interrupted medium
  • Deep 12 V dips during start-up low

Symptoms

  • Hybrid system warning light and MIL on
  • Generator out of operation, vehicle may not reach ready state

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E0F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication