P0E0B
Generator Phase W Current Sensor Circuit High
P0E0B marks a phase W current sensor signal in the generator inverter that sits at the top of its range. In the 2023 Outlander PHEV, Mitsubishi's generator control unit records P0E0B-00 when the W-phase voltage stays at no less than 4.5 V over a period of 0.2 s with a supply of at least 8 V, and turns on the MIL; the 2018 code chart names a short to the supply or a short circuit of current sensor 2. A value like this would match a current well above the generator's capability, so it is judged as a sensor fault, not as overcurrent, which Mitsubishi handles separately with P30A3. The code concerns the W-phase sensor alone; an open phase winding or cable shows up as P0E0C instead. Lower-limit and offset faults of this sensor: P0E0A and P0E09.
Possible causes
- W-phase sensor signal shorted to its supply voltage high
- Current sensor in the power drive unit failed with high output medium
- Lost sensor ground or reference inside the inverter low
Symptoms
- MIL and hybrid system warning light on
- Generator switched off or limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E0B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.