Powertrain
generic / SAE
P0E0A
Generator Phase W Current Sensor Circuit Low
The generator phase W current sensor reports a circuit low fault. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 0A
Possible causes
- Signal wire shorted to ground high
- Internal sensor short medium
- Connector pins corroded - high contact resistance low
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 400–2500 €
- Estimated time: 2–8 h
- Component: generator phase w current sensor
- Component: wiring harness
- Component: hybrid control module
- MIL / check engine light
- limp mode possible
Sources
References
sae:J2012