OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E0A

Generator Phase W Current Sensor Circuit Low

With P0E0A the phase W current sensor of the generator inverter reports a signal at or near zero volts. Mitsubishi covers this code in its Outlander PHEV service information: the 2018 chart attributes it to a short to ground or an open circuit of current sensor 2, and in the 2023 model the generator control unit sets P0E0A-00 after the W-phase voltage has stayed at 0.5 V or lower for 0.2 s with at least 8 V supply, lighting the MIL. On the 2018 two-sensor layout, losing phase W leaves a single measured phase, too little for current control, so generator operation is heavily restricted. Mitsubishi's procedure first deals with codes of higher priority, confirms the fault with a drive cycle and then replaces the power drive unit. Related: P0E09 and P0E0B.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 0A

Possible causes

  • W-phase sensor signal shorted to ground or sensor failed low high
  • Open sensor signal or supply inside the power drive unit medium
  • Input stage of the generator control unit faulty low

Symptoms

  • MIL and hybrid system warning light on
  • Generator largely out of operation
  • Battery is charged noticeably less while driving

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E0A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication