P0E09
Generator Phase W Current Sensor Circuit Range/Performance
P0E09 is the zero-point check of the phase W current sensor in the generator inverter. Mitsubishi uses it on two Outlander PHEV generations. The 2018 code chart lists it as an offset fault of current sensor 2, the second of only two generator current sensors. For 2023 the generator control unit runs the same standstill test as for U and V: IGBTs off, generator under 20 rpm, at least 8 V supply, and the W-phase voltage has to stay inside 2.3 to 2.7 V; 0.32 s outside that band sets P0E09-00 and the MIL. On a two-sensor layout an offset in W also corrupts the V current derived from it, so control quality suffers on two phases at once. Hard signal faults of the same sensor are P0E0A and P0E0B.
Possible causes
- Zero point of the phase W current sensor drifted high
- Sensor supply or reference in the power drive unit unstable medium
- Evaluation in the generator control unit faulty low
Symptoms
- MIL and hybrid system warning light on
- Rough or reduced generator operation
- Fault reappears at the next standstill check after clearing
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E09
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.