P0E07
Generator Phase V Current Sensor Circuit High
P0E07 is set when the phase V current sensor in the generator inverter reports a signal stuck high. Mitsubishi's 2023 Outlander PHEV has its generator control unit flag P0E07-00 as soon as the V-phase voltage is at 4.5 V or above for 0.2 s while its own supply is at least 8 V; MIL and hybrid warning both illuminate. Real current cannot cause such a value, so the fault lies in the sensor, a short to its supply or in the evaluation circuit. The earlier Outlander PHEV, which measured only phases U and W, has no counterpart. When several phase sensors report high at the same moment, a shared supply problem inside the unit is a more likely explanation than three separate defects. Siblings for phase V: P0E05 (offset) and P0E06 (low).
Possible causes
- V-phase sensor signal shorted to its supply high
- Common sensor supply in the power drive unit too high or faulty medium
- Current sensor failed with high output medium
Symptoms
- MIL and hybrid system warning light on
- Generator switched off or limited
- Other phase current sensor codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E07
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.