P0E05
Generator Phase V Current Sensor Circuit Range/Performance
P0E05 reports an implausible zero point of the current sensor in phase V of the generator inverter. Mitsubishi describes it only for the 2023 Outlander PHEV, the first of its generator units with a sensor in phase V; the earlier model measured just U and W. The test mirrors that of the other phases and runs at rest: IGBTs off, generator below 20 rpm, control unit fed with at least 8 V. If the V-phase signal then sits outside 2.3 to 2.7 V for 0.32 s, P0E05-00 is logged and the MIL turns on. As no current can flow in this state, any deviation points to the sensor itself. A zero error left in place would also disturb the three-phase sum check P0DFA, so both codes may appear together. Open or shorted signals of this sensor are P0E06 and P0E07.
Possible causes
- Zero point of the phase V current sensor drifted high
- Disturbed sensor supply or reference in the power drive unit medium
- Generator control unit evaluation faulty low
Symptoms
- MIL and hybrid system warning light on
- Possibly also the phase sum code P0DFA stored
- Less generator support during hybrid driving
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E05
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.