OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E02

Generator Phase U Current Sensor Circuit Low

P0E02 is stored when the output of the generator inverter's phase U current sensor falls to the bottom of its range, a level no real current would produce. Mitsubishi uses it on the Outlander PHEV: from model year 2023 the generator control unit, supplied with at least 8 V, sets P0E02-00 once the U-phase signal drops to 0.5 V or lower and stays there for 0.2 s; unlike the zero-point test, no standstill is needed. The 2018 code chart describes the same code as a ground short or a broken line at current sensor 1. Because the sensor is built into the power drive unit, Mitsubishi's procedure ends with replacing that unit after a confirming drive cycle. The offset check is P0E01, the opposite fault P0E03. Without a valid U-phase value the generator usually runs only in a limited way.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 02

Possible causes

  • Sensor signal shorted to ground or sensor output failed low high
  • Open signal or supply connection of the sensor inside the power drive unit medium
  • Input stage of the generator control unit faulty low

Symptoms

  • MIL and hybrid system warning light on
  • Generator power limited or generator not used
  • Battery charge falls faster in hybrid operation

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E02

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication