OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E00

Generator Phase U Current Sensor Circuit

P0E00 is the general circuit code for the current sensor in phase U of the generator. Each phase sensor, usually a Hall-type device inside the inverter, outputs a voltage around a mid-point when no current flows. No manufacturer documents P0E00 publicly. Mitsubishi's Outlander PHEV shows how its generator unit judges the U-phase sensor: at standstill below 20 rpm with the IGBTs off the signal must stay between 2.3 and 2.7 V (P0E01-00 after 0.32 s), and readings of 0.5 V and lower, or 4.5 V and higher, held for 0.2 s set P0E02-00 or P0E03-00. P0E00 is meant for circuit faults outside these categories. Without the signal the inverter cannot regulate generator torque properly. Phases V and W are P0E04 and P0E08.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 00

Possible causes

  • Supply or reference fault of the current sensor medium
  • Defective phase U current sensor inside the inverter medium
  • Faulty internal connection between sensor and control board low

Symptoms

  • Hybrid system warning and engine warning light
  • Generator switched off, reduced performance
  • Vehicle may not reach ready mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E00

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication