P0DFE
Battery Charger Coolant Control Valve Control Circuit Low
P0DFE means the control line of the charger coolant valve reads low, usually because it is shorted to ground somewhere between driver and valve. No manufacturer documents P0DFE publicly. GM's 2011 Volt tables show how such a check works on battery coolant valve A (P0CE2): with system voltage above 9 V and the valve commanded in reverse, a low sense level on drive 1 counts as a failure, and the code needs a fault in 90 of 100 checks spaced 6.25 ms apart before it is set as a two-trip Type B code. For the charger valve a similar logic is likely but not published. A ground short typically freezes the valve where it is, so the charger may be left without coolant and lower its power. Look for chafed wires and wet connectors. Open circuit is P0DFD.
Possible causes
- Control wire chafed through and shorted to ground high
- Coolant or water in the valve connector medium
- Internal short in the valve actuator medium
Symptoms
- Reduced charging power, longer charging time
- Charger warning or charging stops
- Driving normally unaffected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0DFE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.