P0DFC
Generator Position Sensor Not Learned
P0DFC is stored when the controller has no valid learned position offset for the generator resolver. Ford explains it in the OBD summary of its power-split hybrids: the code appears when the resolver was not configured at the assembly plant or after the inverter system controller has been replaced, and the check fails if the value held in EEPROM is outside its accepted range. It runs continuously from 700 ms after power-up with 6 to 19 V on the 12 V system, and Ford's 2014 code list marks P0DFC as a MIL code. Volvo reported intermittent IGM-P0DFC00 entries without symptoms on 2016 to 2017 XC90 T8 models and later released new IGM software. After a module or generator replacement, run the learn procedure. The drive motor counterpart is P0C17.
Possible causes
- Inverter or hybrid controller replaced without resolver learning high
- Software fault in the inverter generator module (Volvo, update available) medium
- Stored offset lost or corrupted in EEPROM low
Symptoms
- Engine warning light on
- Generator or hybrid functions restricted
- Sometimes only stored as history code without symptoms
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DFC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.