P0DFB
Generator Position Exceeding Learn Limit
The position sensor of a hybrid generator, normally a resolver, is never mounted exactly in line with the magnetic poles of the rotor. The remaining angle error is determined once and saved in the controller; Hyundai describes doing this after assembly and again whenever the machine or its control unit is replaced, and Ford describes an in-vehicle routine started by a scan tool that sweeps the current angle and reads the offset where the q-axis current crosses zero. P0DFB means such a learned offset lies outside the window the software accepts, so it cannot be used for field-oriented control. No manufacturer documents P0DFB publicly. Possible reasons are a resolver that moved on its shaft, an aborted learning run or a faulty controller. A missing value is P0DFC instead.
Possible causes
- Offset learning interrupted or run under wrong conditions high
- Resolver rotor or stator shifted after repair or damage medium
- Fault or wrong software in the generator control unit low
Symptoms
- Hybrid system warning and engine warning light
- Generator not used, reduced charging or engine start problems
- Code returns after clearing until relearned
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DFB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.