P0DFA
Generator Phase U-V-W Current Sensor Correlation
In a three-phase machine the currents of phases U, V and W add up to nearly zero at every instant, so a sum far from zero shows that at least one current sensor is wrong. P0DFA is the code for this cross-check on the generator side. Mitsubishi documents it for the Outlander PHEV: with the IGBTs switching, the summation check must not report a failure, and with them off the sum must stay below 140 A; either condition held for 0.35 s sets P0DFA-00. Ford counts P0DFA among the generator inverter faults of its power-split hybrids, and SSM 50151 notes that on 2020 to 2021 hybrid models it can be caused by a 12 V dip at key-on, so check for low voltage first. Single-phase sensor faults are P0E00 to P0E0B.
Possible causes
- 12 V voltage drop at key-on (Ford SSM 50151) medium
- One phase current sensor with offset or gain error medium
- Internal fault of the inverter or power drive unit medium
Symptoms
- Stop Safely Now or hybrid system warning
- Vehicle may not start or ready mode is refused
- Generator shut down, restricted driving
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DFA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.