P0DF8
Generator Inverter Temperature Sensor C Circuit Low
P0DF8 tells that temperature sensor C in the generator inverter delivers a voltage below its valid range. Mitsubishi uses the code in the Outlander PHEV for the W-phase high-side IGBT sensor: a reading at or under 1.25 V for 0.08 s, with at least 8 V GCU supply, stores P0DF8-00, and the check runs all the time. Physical causes are a short between signal and ground or a breakdown inside the module, for instance after coolant has reached the electronics. The value suggests a far too hot switch, so the controller derates the generator to stay on the safe side. The sensor cannot be replaced on its own, which is why Mitsubishi lists the power drive unit. The same fault on sensor B is P0DF5, the high case on this sensor P0DF9.
Possible causes
- Signal line of sensor C shorted to ground medium
- Coolant or moisture inside the inverter electronics low
- Shorted sensor or internal fault of the power drive unit medium
Symptoms
- Hybrid or engine warning light on
- Generator power limited
- Implausibly high inverter temperature in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DF8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.