P0DF7
Generator Inverter Temperature Sensor C Circuit Range/Performance
P0DF7 is the plausibility code for temperature sensor C of the generator inverter. The idea behind it: after a long rest every power switch should be at roughly the same temperature, so a sensor that stands out is suspect. In Mitsubishi's Outlander PHEV the W-phase high-side sensor is compared once per trip, after 600 s or more of soak and with the IGBTs off, against the U- and V-phase sensors; a gap above 47 °C lasting 0.1 s stores P0DF7-00. The circuit itself is electrically fine in this case, so wiring checks rarely help, and Mitsubishi's procedure replaces the power drive unit. A genuine overheat of the inverter is reported separately as P0A3E. The same comparison on sensor B is P0DF4.
Possible causes
- Sensor C drifted or stuck inside the IGBT module high
- Internal fault of the power drive unit medium
- Control software misjudging the comparison low
Symptoms
- Engine warning light on after a cold start
- Usually no noticeable change in driving
- Possibly reduced generator power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DF7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.