OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DF6

Generator Inverter Temperature Sensor B Circuit High

P0DF6 is the high-signal case for sensor B in the generator inverter. In the Outlander PHEV Mitsubishi stores P0DF6-00 when the V-phase high-side IGBT sensor voltage reaches at least 3.75 V during 0.08 s, again only with a GCU supply of at least 8 V. A voltage at the upper limit mostly points to an interrupted sensor line, a lost reference ground or a cracked element; with the common NTC layout it reads as an implausibly cold module. Since the inverter can then no longer protect its switches against overheating, the controller works with a safe substitute and may cut generator output. Mitsubishi's procedure ends with a new power drive unit. Too low a signal on this sensor is P0DF5; the same open-type fault on sensor C would be P0DF9.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / F6

Possible causes

  • Open signal line or backed-out terminal medium
  • Lost sensor reference ground medium
  • Cracked sensor element or internal fault of the power drive unit medium

Symptoms

  • Engine or hybrid warning light on
  • Inverter temperature shown far too low
  • Generator power reduced

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DF6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication