P0DF4
Generator Inverter Temperature Sensor B Circuit Range/Performance
P0DF4 reports that temperature sensor B of the generator inverter delivers an electrically valid signal whose value does not fit the other sensors. Mitsubishi documents the check for the Outlander PHEV: a single time in each drive cycle, following at least 600 s of standstill and with the IGBTs switched off, the V-phase high-side sensor may not differ by more than 47 °C from the other two phase sensors for 0.1 s; otherwise P0DF4-00 is stored and the power drive unit is replaced. Volvo lists ECM P0DF400 for 2022-on T8 plug-in hybrids and warns it can be misdetected, showing Propulsion System Service Required; for builds from week 202147 to 202446 ECM software 3.4.4 cures it. Out-of-range signals are P0DF5 and P0DF6.
Possible causes
- Control software misdetection (Volvo T8, ECM update available) high
- Sensor in the power module drifted or stuck at one value medium
- Internal fault in the power drive unit (Mitsubishi replaces the unit) medium
Symptoms
- Message such as Propulsion System Service Required
- Engine warning light on
- Turtle symbol and reduced power in some cases
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DF4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.