P0DF3
Generator Inverter Temperature Sensor C Circuit Intermittent/Erratic
P0DF3 is logged when sensor C in the generator inverter delivers an unsteady signal: short spikes, gaps or values that change faster than the module temperature ever could. Such faults often start at connectors that loosen under engine vibration and repeated heating cycles, or at pins attacked by moisture. No manufacturer documents P0DF3 publicly, and Mitsubishi, which does monitor a W-phase sensor in its generator unit, defines no intermittent code for it. CARB requires these thermal inputs to be monitored nonetheless. The warning may vanish after a restart and return days later, so it pays to note when and under which load it appeared. Constant faults of the same sensor are P0DF2, P0DF8 and P0DF9; the matching fault on sensor B is P0DF1.
Possible causes
- Terminal losing contact under vibration or heat cycles high
- Moisture or corrosion in the inverter connector medium
- Intermittent connection inside the inverter module low
Symptoms
- Warning light that appears only now and then
- Brief drops in generator power
- Code stored as history fault without current symptoms
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0DF3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.