P0DF2
Generator Inverter Temperature Sensor C Circuit
P0DF2 covers an electrical fault on temperature sensor C of the generator inverter that the controller cannot assign to a more specific low, high or intermittent code. Which power switch carries sensor C is up to the manufacturer; in Mitsubishi's Outlander PHEV the third high-side IGBT sensor sits on the W phase, and its faults are logged only as P0DF7 to P0DF9. No manufacturer documents P0DF2 itself. CARB demands circuit monitoring for inputs of inverter thermal management. As these thermistors are usually built into the IGBT module, a confirmed sensor fault often means replacing the inverter or the complete power unit, so the harness and connector deserve a careful check first. The general circuit code for sensor B is P0DF0.
Possible causes
- Thermistor inside the IGBT module defective medium
- Connector or signal line fault between module and controller medium
- Faulty input stage in the generator control unit low
Symptoms
- Hybrid or engine warning light on
- Generator power reduced as a precaution
- Higher engine use or weaker battery recharge
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DF2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.