P0DF0
Generator Inverter Temperature Sensor B Circuit
P0DF0 is the catch-all circuit code for temperature sensor B in the generator inverter, the power stage that drives the generator of a two-machine hybrid. The controller sets it when the sensor line is electrically faulty but the fault is not sorted into low, high or erratic. No manufacturer documents P0DF0 publicly. Mitsubishi fits one thermistor per IGBT in the generator unit of the Outlander PHEV and reports the second high-side sensor (V phase) only through P0DF4 to P0DF6, never through this general code; Ford likewise names only open and short checks for its generator inverter sensor. CARB requires every input that feeds inverter thermal management to be checked for circuit faults. Without a valid value the controller has to assume the worst and usually limits generator output.
Possible causes
- Loose, corroded or damaged connector at the inverter or power unit medium
- Thermistor or its signal path inside the inverter module faulty medium
- Faulty evaluation input in the generator control unit low
Symptoms
- Hybrid or engine warning light on
- Reduced generator output, weaker charging while driving
- Hybrid system may switch to a restricted mode
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DF0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.