P0DEE
Pedestrian Alert Control Module Circuit Low
P0DEE is set when the hard-wired circuit to the pedestrian alert control module sits below its expected voltage, typically from a short to ground. No manufacturer documents P0DEE publicly, so the exact signal behind it, whether supply, wake-up or a command line, is not known in detail. A ground short often blows a fuse or makes the driving module disconnect the line, and the alert then falls silent, even though FMVSS 141 expects a sound from standstill with propulsion on, in reverse and up to around 30 km/h; EU vehicles must carry such a system as well. Look along the whole harness run, which can be long: on Ford's 2020-21 Escape Hybrid the module sits in the right rear quarter. Open circuit is P0DED, short to voltage P0DEF.
Possible causes
- Chafed or crushed wire shorting to ground high
- Water ingress in a connector near bumper or wheel arch medium
- Internal short in the alert module low
Symptoms
- Pedestrian warning sound missing
- Warning message in the instrument cluster
- Fuse for the alert module may be blown
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0DEE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.