OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DEB

Hybrid/EV Battery Pack Coolant Control Valve C Control Circuit Low

P0DEB is set when the drive line of coolant control valve C reads too low, which almost always means a short to ground somewhere between controller and valve. No manufacturer documents P0DEB publicly. GM's 2011 Volt tables for valve A show the logic: with system voltage above 9 V, a low reading on driver line 1 during reverse travel counts as a failure, and 90 failures out of 100 samples at 6.25 ms set a Type B code. A short to ground lets current bypass the load, so many drivers protect themselves by shutting off; an overheated or overloaded driver has its own code, P0E22. Chafed insulation near brackets, coolant in the connector and an internal short in the valve motor are the usual finds. The valve then stays wherever it was. Open circuit is P0DE8, short to voltage P0DEC.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / EB

Possible causes

  • Chafed wire shorting to body ground high
  • Coolant or water in the valve connector medium
  • Internal short in the valve motor medium

Symptoms

  • Valve C no longer moves, temperature control in fallback mode
  • Charging or drive power reduced at temperature extremes
  • Malfunction indicator lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0DEB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication