OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DE9

Hybrid/EV Battery Pack Coolant Control Valve C Performance/Stuck Off

P0DE9 says coolant control valve C is electrically fine but does not do its job: it fails to reach the commanded position or remains in its off state. No manufacturer documents P0DE9 publicly. GM's 2011 Chevrolet Volt tables show what such a test can look like for valve A, which has a position feedback: on start-up the valve must find its end stop within 800 ms, later it must reach each target within 1.5 s, and an erratic feedback with more than 12 % noise counts as well; enough failed samples set a Type B code with the MIL on the second trip. Where no feedback exists, makers judge the valve from coolant or pack temperatures, which CARB requests as a functional check of cooling. Dirt, a seized valve body or a weak actuator are typical. Stuck on is P0DEA.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / E9

Possible causes

  • Valve body seized or sluggish from deposits high
  • Worn actuator motor or gearing in valve C medium
  • Low coolant or air in the battery loop distorting the temperature check medium
  • Overly tight diagnostic calibration low

Symptoms

  • Battery heats up faster under load or while fast charging
  • Charging power or drive power limited
  • Malfunction indicator lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0DE9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication