OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DE1

Hybrid/EV Battery Cell Balancing Circuit N Stuck On

P0DE1 is the last stuck-on code of the series: group N keeps bleeding when it should rest. Ford lists it in every hybrid OBD summary from 2014 to 2019; in the 2017 edition the BECM spends 100 ms after key-on, while the contactors are still open, checking whether any of the six cells of circuit N sits more than 75 mV from the average, with two consecutive power cycles needed. A balancing switch that cannot open drains the group constantly, even with the car parked, and turns that energy into heat on the board. A cell with an internal short can produce the same falling voltage, so a check of the switch on the bench is worthwhile before the cells are condemned. Ford's 2014 code list ties the code to the MIL. Inactive case: P0DE2.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / E1

Possible causes

  • Balancing switch of group N permanently conducting high
  • Cell of group N with an internal short causing the same voltage drop low
  • Monitoring electronics keeping the balancing command for N active medium

Symptoms

  • Check engine light after switching on
  • Group N drops while the car is parked
  • Shorter electric range

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DE1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication