OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DDE

Hybrid/EV Battery Cell Balancing Circuit M Stuck Off

P0DDE means group M is not bled when it should be. Ford carries the code in its 2016 hybrid OBD summary with the usual BECM start-up rule: 100 ms with open contactors, six cells per circuit, a 75 mV gap to the average, confirmed over two power cycles. A balancing channel can also be stopped on purpose, which a diagnosis must keep apart from a real failure. TI's BQ79616-Q1 data sheet lists such ends: the per-channel timer expires, the cell falls below a set voltage, an unmasked fault appears or the host stops balancing. Only a path that never conducts after a valid start counts here. Left alone, the fuller cells of M reach their limit first at every charge, and the pack gives away capacity. Stuck-on case: P0DDD.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / DE

Possible causes

  • Bleed resistor of circuit M open high
  • Balancing switch of group M that no longer turns on medium
  • Intended balancing stop for M misjudged as no response by the software low

Symptoms

  • Check engine light while driving feels normal
  • Group M highest at the end of each charge
  • Less usable battery energy over time

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DDE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication