OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DD9

Hybrid/EV Battery Cell Balancing Circuit L Stuck On

P0DD9: the balancing path of group L will not switch off. The 2018 edition of Ford's hybrid OBD summary contains the code; the BECM catches it at power-up with the contactors still open, in a 100 ms check that compares each of the six cells of circuit L with the average and fails above 75 mV, again over two power cycles. GM shows a different route in its 2013 eAssist table: code P1B33 compares the reported balancing switch status with the commanded one and fails after 7 of 10 samples, as a two-trip fault. A switch that reads on while it should be off is exactly what P0DD9 describes. While parked the group drains, and the warm resistor stresses the module. Inactive opposite: P0DDA.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / D9

Possible causes

  • Balancing switch of group L shorted high
  • Switch status feedback of channel L reporting on although the switch is open low
  • Balancing command for L not cleared by the monitoring electronics medium

Symptoms

  • Check engine light after switching on
  • Group L lower than the others after standing
  • Less electric range

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DD9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication