P0DD4
Hybrid/EV Battery Cell Balancing Circuit K
P0DD4 is the electrical fault code for balancing circuit K, the eleventh group, so it only exists on packs with at least eleven balancing channels. Public maker documents for this exact code were not found; Ford's summaries give K only to the stuck faults P0DD5 and P0DD6. How a monitoring chip catches broken wiring is shown in Infineon's TLE9012DQU data sheet: during its round-robin cycle the chip sinks a test current of about 15 mA into each balancing pin, odd channels in one cycle and even ones in the next, and flags a broken wire or missing load when the resulting change in cell voltage falls outside a set window. CARB 13 CCR 1968.2 requires such components to be monitored on hybrids. Related: P0DD5 to P0DD7.
Possible causes
- Open wire or loose cell tap in group K high
- Corrosion or moisture at the connector of the monitoring board for K medium
- Defective monitoring chip or external balancing part of channel K low
Symptoms
- Check engine light and hybrid system warning
- Missing or implausible cell voltages for group K in the scan tool
- Reduced charging or drive power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DD4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.